During the summer of 2024 Elegoo has announced a successor in the Mars series. The new Mars 5 and Mars 5 Ultra were announced. With previous printer releases Elegoo would make the Ultra slightly fancier, or slightly faster. So mostly minor changes. With this new release they used a higher resolution LCD screen in the Mars 5 Ultra (9K) vs. the Mars 5 (4K). This is an odd move as the Mars 3 used a 4K screen while the Mars 4 was already upgraded to a 9K screen. See the full printer comparison below. The Elegoo Mars 5 Ultra (9K edition) has a build volume of 153,36 x 77,76 x 165 mm , with its 9K LCD screen this results in a pixel size of 18 microns. In this article you can find print parameters for the Elegoo Mars 5 Ultra. If you are looking for Elegoo Mars 5 (4K) resin parameters you can find it in the link.
While dialing in our Elastomer-X and Composite-X resin on the Mars 5 Ultra, we noticed that both resins needs a bit of extra attention and caution to work with.
First of all, set the printer to slow print speed for all flexible 3D-printing resin. You can do this in the Mars 5 Ultra printer menu. Next, use heavy supports like always with flexible resin, find more instructions on that in the link. For Composite-X the slow printing setting with medium supports is sufficient. Now we have only tested small and medium parts. When the room/resin is cold, it can happen that the printer says that it detects “foreign matter detected, please troubleshoot”. here it gets a bit crazy, because Elastomer-X and Composite-X are quite thick liquids at room temperature. The Mars 5 Ultra thinks that there is some plastic leftover from the previous build. To print you either have to warm the resin. Or the second option is to over-rule. When over-ruling you have to be very sure that everything is clean and that it only detects the resin.
Image of the message that the machine shows when the platform hits the Elastomer-X and Composite-X resin for the first time.
3D-pringint parameters for Elastomer-X and Composite-X resin on the Mars 5 Ultra
If you are taking all these things on consideration and need to print small and medium parts, then these settings can work:
| Resin | Layer thickness | Exposure time (seconds) | Base layer /transition layers | Base layer exposure | Speed | Waiting mode | Rest time per step (seconds) |
| Elastomer-X | 100 µm | 14,0 | 2 / 10 | 80 | Slow | Resting Time | 2,0/0/0,5 |
| Composite-X | 100 µm | 7,0 | 3 / 10 | 70 | Slow | Resting Time | 2,0/0/0,5 |
Contact us if you have any questions or when you need help with settings for Liqcreate resin with the Elegoo Mars series or other resin based 3D-printers.
Support
Do you need any help with 3D printing our SLA, DLP or LCD resins? We can help you! Just look for the question you have below. If you can’t find it, let us know by contacting us!
